arduino

Arduino Accessories

!
Arduino®
Delivery time:1-5 Days
A000014

Arduino USB/Serial converter with Headers A000014

Web Offer Price
   Module: Pre-assembled
This board converts a USB connection to the 5V TX and RX an Arduino requires for communication. You can connect straight to the Arduino Mini or other microcontrollers, allowing them to talk to the computer.

It is based on the FT232RL chip from FTDI (drivers are included with the Arduino software).

Arduino®
Delivery time:1-5 Days
A000059

Arduino USB 2 Serial Converter A000059

Web Offer Price
   Module: Pre-assembled
This board converts a USB connection into 5 volt TX and RX that you can connect straight to the Arduino Ethernet or any other boards with an FTDI cable-compatible connector.

It features the Atmega8U2 programmed as a USB-to-serial converter, the same chip found on the Arduino Uno. The USB Serial module has an ISCP interface, allowing you to reprogram the chip when placed in DFU mode. The pin outs on the connector are compatible with a standard FTDI header (as well as the Adafruit and Sparkfun USB-Serial adapters).

Arduino®
Delivery time:1-5 Days
A000092

Arduino ISP A000092

   Module: Pre-assembled

This accessory allows you to program your Arduino board through the ISP connector.

With this programmer you can upload sketches and burn the bootloader on any Arduino (or other brand) AVR based boards through the ISP connector. By uploading a sketch with an external programmer you can remove the bootloader and use the extra space for your sketch.

The Arduino ISP can also be used to burn the bootloader on your Arduino, so you can recover it if you accidentally corrupt the bootloader. Burning the bootloader is also necessary when you use a new ATmega microcontroller in your Arduino, and you need the bootloader in order to upload a sketch in the usual way.

Arduino®
Delivery time:1-5 Days
ATMega328
Weight: kg
a000048

ATMega328 Preloaded Mircocontroller A000048

Quantity Discount Prices Available

A preloaded microcontroller with Arduino UNO Boot Loader.

The ATmega328P is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328P achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

Velleman
5410329588250
Delivery time:1-5 Days
336-345
Weight: kg

10 Piece HQ Jumper Wire Pack M-F WJW005

A Pack of 10 jump wires with female connector at one end and male at the other, ideal for use with pin headers. Each pack contains 10 x 150mm jump wires (Red, White, Blue, Green. Orange, Yellow, Purple, Brown, Grey and Black). Ideal for linking development boards like Arduino or Raspberry Pie to breadboards.
Velleman
5410329588267
Delivery time:1-5 Days
336-365
Weight: kg

10 Piece HQ Jumper Wire Pack F-F WJW006

A Pack of 10 jump wires with female connector at each end, ideal for use with pin headers. Each pack contains 10 x 150mm jump wires (Red, White, Blue, Green. Orange, Yellow, Purple, Brown, Grey and Black). Ideal for linking development boards like Arduino or Raspberry Pie etc.