!
!
Arduino®
Delivery time:1-5 Days
A000089

Arduino WiFi Shield with Antenna Connector A000089

Web Offer Price
   Module: Pre-assembled
The Arduino WiFi Shield connects your Arduino to the internet wirelessly. Connect it to your wireless network by following a few simple instructions to start controlling your world through the internet. As always with Arduino, every element of the platform – hardware, software and documentation – is freely available and open-source. This means you can learn exactly how it's made and use its design as the starting point for your own circuits. Check out the reference page of the WiFi library to understand how the shield can easily provide an internet connection to your Arduino board.

The WiFi Shield communicates with Arduino using the SPI bus (through the ICSP header), so is compatible with any of the boards that have this type of bus. This version of WiFi shield has an antenna connector, simply add your own antenna.

Arduino®
Delivery time:to be confirmed
A000106
Weight: kg

Arduino GSM Shield 2 with connector A000106

Web Offer Price
   Module: Pre-assembled
new 

 New - Awaiting due date 

The Arduino GSM Shield connects your Arduino to the internet using the GPRS wireless network. Just plug this module onto your Arduino board, plug in a SIM card from an operator offering GPRS coverage and follow a few simple instructions to start controlling your world through the internet. You can also make/receive voice calls (you will need an external speaker and microphone circuit) and send/receive SMS messages.

  • Requires an Arduino board (not included)
  • Operating voltage 5V (supplied from the Arduino Board)
  • Connection with Arduino Uno on pins 2, 3 (Software Serial) and 7 (reset).
  • This board features an Antenna Connector
Arduino®
Delivery time:to be confirmed
A000110
Weight: kg

Arduino 4 Relay Shield A000110

Web Offer Price
   Module: Pre-assembled

The Arduino 4 Relays Shield is a solution for driving high power loads that cannot be controlled by Arduino's digital IOs, due to the current and voltage limits of the controller.

The Shield features four relays, each relay provides 2 pole changeover contacts (NO and NC); in order to increase the current limit of each output the 2 changeover contacts have been put in parallel. Four LEDs indicate the on/off state of each relay.

Arduino®
Delivery time:1-5 Days
TXS000083

Arduino Proto Shield Rev 3 (PCB) TXS000083

The ProtoShield makes it easy for you to design custom circuits. You can easily solder TH or SMD ICs on the prototyping area to test them with your Arduino board. The SMD area is designed for a maximum of 24 pins SOIC integrated circuit and the TH area contains a lot of space for the needed components around your project. You can even stick a mini breadboard (not included) on the protoarea for solderless operation. The proto area includes also two power lines (IOREF and GND), two LEDs pads and SPI signals breakout pads for boards with SPI only on the ICSP header like Zero. Supplied with headers.